Maintenance method of stainless steel faucet handle

Maintenance method of stainless steel faucet handle

Faucet often sees in kitchen and toilet, handle commonly has single and double these two kinds of shapes. Kitchen faucet, it is recommended to choose a single, and choose the faucet handle is longer, because in the kitchen, holding other things in the hand, perhaps the hand is oily, this time with the back of the hand can switch the faucet appears more convenient.

Generally, the common phenomenon of faucet damage is that the sealing is not tight, there is dripping phenomenon, and then the poor quality switch handle is broken. It can also be because the rubber ring of the handle is loose and aging after a long time of using the faucet, which leads to the sealing is not tight and water leakage. At this time, you only need to replace the rubber ring or the faucet valve core.

The shower faucet that toilet uses, if what the home uses is gas water heater, choose double bibcock to be convenient a lot of, although gas water heater a lot of now are constant temperature, but because the body feeling of everybody in the home is different, so when using still want to use bibcock to mix water to undertake the fine adjustment of temperature.

Generally, when a single faucet is used for conditioning, the water quantity of the hot water pipe and the cold water pipe changes together, which is not easy to master. However, it is convenient to use the double faucet. Just turn on the hot water faucet to a large amount first, and then turn on the cold water faucet to a suitable amount. Moreover, for some water heaters without low-pressure start-up, the water quantity of the hot water pipe is always large, so it is not easy The phenomenon that the water heater can be saved when the water temperature is adjusted.

If the handle is damaged, you don't need to buy a new one. Find an old one or a good handle you used to replace. Remove the fixing screw from the top and you can replace it. The screw is usually covered by some trademarks. You just need to tear the trademark to find the screw. If it is closed laxly, it is generally necessary to do replacement treatment, because the general faucet fixed base is one-time, if the sealing lax leakage phenomenon, that treatment as long as buy a new replacement, replacement is also very simple, in the time to buy the faucet, take the opportunity to spend 2 yuan to buy a roll of water pipe special sealing belt, it can, change the time, just use a pipe wrench or wrench to replace the original Remove the faucet, clean the water outlet, wrap the sealing belt, and screw the faucet. It doesn't need to be too tight when screwing. If it's not in place, you can control the angle of the faucet by adjusting the thickness of the sealing belt.

Generally, the fixed pieces of the control part of the faucet are plastic or very thin metal pieces. When the faucet is closed in place, some people think that it is necessary to use a lot of force to close it tightly. In fact, it is very simple to damage the control part and break the bamboo shoots of the control part. Therefore, when closing and turning on the faucet, we should develop the habit of light exertion and reaching the designated position, so as to ensure the long-term use of the faucet. Another way is: remove the set screw from the hiding set screw, and then remove the handle. After removing the handle, there is a large hexagon nut inside. Carefully screw off the big nut to take off the valve core. After replacing the valve core with a new one, it can be handled according to the opposite order.