Installation and acceptance of common faucet parts

Installation and acceptance of common faucet parts

First of all, prepare to place things. Before placement, check whether the supporting parts are complete. Common faucet parts include: hose, rubber washer, shower, water removal, crutch, decorative cap, etc.

Installation of single hole basin faucet

When you buy a single hand basin faucet, you should pay attention to the diameter of the water outlet. Nowadays, most of the faucets in the market are hard pipe water inlet, so you should pay attention to the height of the water inlet, which is 35 work points down from the basin. When installing, the special angle valve must be selected, and the angle valve must be firmly connected with the cold and hot water pipes of the wall outlet. When you invent that there is a gap between the angle valve and the water supply pipe of the faucet, buy a special extension pipe to connect. Remember, do not use other water pipes to connect, because if the water pressure is high, it is very convenient to fall off, leak, and cause loss to you. If the inlet pipe is too long, it can be cut off according to your need. If the angle does not meet the requirement, it can be moderately bent to your necessary position. Remember: don't bend hard to 90 degrees or more. When installing the basin to drain, please don't forget to purchase the small connector of the faucet (short connection of the faucet). Please don't forget to flush the water pipes buried in the wall before you place them.

Arrangement of shower and bathtub faucet (hanging wall)

When you buy a shower, bathtub, wall faucet, you can choose the height to meet the buried water pipe. The distance between hot and cold water pipes must reach 15 cm. Before placement, you must not forget to flush the water pipe, so as not to damage the faucet due to the water quality.

Concealed shower and Bathtub Faucet: after purchasing concealed faucet, the valve core of faucet is usually embedded in the wall. Pay attention to the thickness of toilet wall before embedding. If the wall is too thin, the valve core will not be embedded. The plastic cover of the valve core should not be removed easily when it is embedded, so as not to damage the valve core by cement and other chores. Other embedded in the spool should also pay attention to the spool up and down, left and right deviation, in order to avoid the spool buried wrong. The size of the embedded water inlet pipe of the wall mounted faucet is defective, so it can be adjusted and adjusted.

Installation of constant temperature tap

Before installing the thermostatic faucet, please check whether the water pipe is hot on the left and cold on the right, and remember not to connect the cold and hot water pipes wrong, so as to avoid that the faucet cannot do normal things. Gas, solar water heaters can not use constant temperature faucet, because the water pressure is too low. Please don't forget to install cold and hot water filter screen when installing thermostatic faucet.

Installation of Single Hole Kitchen Faucet

Stable requirements, due to the high frequency of kitchen faucet utilization, coupled with being moved left to right, easy to loose, so the lock nut must be tightened. Now, there are some faucets in the market. The screw tube is enlarged and the nut is firm. This kind of stable condensation result is very good. If we can deal with the problem of removing water and pulling, it will be a popular trend in the future.